SVST Ski Boot Flat Riser Plates

Flat riser plates that sit under the toe and heel of a boot on the bench, giving consistent, repeatable support while you work.

They are available in 4 mm and 6 mm, and the point is consistency rather than height: a boot supported the same way every time means measurements and adjustments that transfer from one session to the next.

• Flat plastic construction
• 4 mm or 6 mm thickness
• Consistent support under toe and heel
• For precise boot fitting and alignment work

Flat plates or canted plates? These are flat — they raise without changing the angle. For correcting the angle of a boot sole, you want the cant plates, which come in 1°, 1.5°, 2° and 3°.

A rules note: anything that changes stand height counts toward the 50 mm maximum for ski, plate and binding combined in most age classes. Bench support does not, but permanent boot risers do — check before making a change permanent on a race setup.

This is workshop equipment. If you have a fit or alignment problem rather than a tooling one, that is a job for a bootfitter.

See our boot fitting range.